凝胶注模法制备锥管串接式阳极支撑固体氧化物燃料电池及其性能研究

作者：Ye Zibin; Zhou Mingyang; Zou Gaochang; Gu Xiaofeng; Wu Qiwen; Liu Jiang^*

来源：Journal of Ceramics, 2023, 44(4): 761-768.

DOI：10.13957/j.cnki.tcxb.2023.04.017

• anode support
• cone-shaped segmented-in-series
• gel-casting technique
• solid oxide fuel cell

Tubular cone-shaped anode-supported segmented-in-series solid oxide fuel cells are prepared by using a water-based gel-casting technique with acrylamide as the monomer. In preparing the green body of the porous cone-shaped anode (NiO-YSZ) support, by using the gel-casting technique, the reaction temperature is set at 90 °C, without the requirement of initiator and catalyst. Then, the green anode is prefired at 1200 °C. An electrolyte (YSZ) film is coated on outside of the anode support by using dip-coating technique and the bilayer is co-sintered at 1400 ℃. A cathode (Ag-GDC) is applied on the electrolyte by using brush-painting, which is then sintered at 850 ℃. The as-prepared tubular anode-supported cell gives a peak power density of 693 mW·cm?2 at 800 ℃. The segmented-in-series two-cell-stack shows an open circuit voltage of 2.06 V and a peak power of 2.31 W at 800 ℃ with an area of 4.1 cm2 ? 2023 Chinese Journal of General Practitioners.

• 单位
  华南理工大学